What is electrical appliance thermal transfer processing? What are the operation steps?

1-What is electrical appliance thermal transfer processing? What are the operation steps?
Electrical appliance thermal transfer processing is a common processing technology, which mainly transfers a layer of exquisite patterns on the flat or curved surface of electrical appliances. Thermal transfer processing can not only add luster to the product, but also improve the grade and appearance of the product.

Customers come to the workpiece → make the corresponding fixture → preheat the thermal transfer machine → install it into a roll film → place the appliance on the fixture → start the foot switch → transfer the film → complete the processing.

Electrical appliance thermal transfer product large picture

2-What are the characteristics of electrical appliance thermal transfer processing?

1. The pattern after transfer has strong covering power, and the loss of electrical products is reduced.

2. The processing process will not produce air pollution and wastewater pollution, which is in line with the country's green environmental protection concept.

3. The operation is simple and convenient. As long as the machine is preheated in advance, the temperature and pressure are adjusted, the product is placed in the designated position, and the foot pedal is gently started, the transfer can be easily completed.

4. Because electrical appliances are hot-stamped with high temperature and high pressure using a heat transfer machine, the adhesion of the flower film is very strong and will not fade after long-term use.

3 What matters need to be paid attention to in the heat transfer processing of electrical appliances?
In the heat transfer processing of electrical appliances, problems of one kind or another often occur. If you want to improve the quality of transfer, you must pay attention to the following matters.

1. Hot stamping temperature

The hot stamping temperature needs to be confirmed according to the properties of the electrical appliance, and it should be adjusted based on the effect after hot stamping.

2. Hot stamping pressure

The hot stamping pressure must be adjusted to the appropriate level. When the pressure is too high, it will damage the rubber head and the electrical appliance. When the pressure is too low, the adhesion is not ideal.

3. Hot stamping speed

The hot stamping speed should be determined according to the specific hot stamping object. The faster the speed, the higher the production efficiency while ensuring the hot stamping effect. However, for some products, due to certain special conditions, it is recommended to use slow hot stamping.

4. Cleaning work

For the cleaning link, everyone must be familiar with it, because it will often be seen in the maintenance of other machine articles, and the same is true for hot transfer in the processing of electrical appliances.

Parts that need to be kept clean: workbench, guide rollers, buttons, flower films, rubber heads, substrates (electrical appliances). Since the processing is semi-automatic, the operator must keep his hands clean during the transfer process to avoid dust that may affect the transfer effect of the electrical appliance.